Seat Control Switch - 6-Way

SEAT CONTROL SWITCH - 6-WAY

Removal

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Driver seat is shown, passenger is similar.

1. Remove the affected seat and depower the SRS.







2. Disconnect the 6-way power seat switch electrical connector.







3. Remove the recliner handle screw cover.







4. Remove the recliner handle screw and the recliner handle.







5. CAUTION: Use care when removing the lumbar knob. Using both hands, pull with even pressure on both sides of the knob to remove.

Pull out to remove the lumbar knob.







6. Remove the screw from the side shield under the lumbar knob.







7. CAUTION: Use care not to scratch the side shield when removing the power seat knob.

Pry the power seat knob off.







8. Access and remove the front side shield screw.







9. Pull to release the center retainer on side shield.







10. Pull to release the retainer clip on the rear of side shield.
11. Remove the side shield from the seat.







12. Remove the two screws and remove the 6-way power seat switch from the side shield.

Installation







1. Install the 6-way power seat switch on the side shield and install the two screws.







2. Push to install the rear side shield retainer on seat frame.







3. Push to install the middle side shield retainer on the seat.







4. Access and install the front side shield screw.







5. Install the 6-way power seat knob.







6. Install the screw on the side shield under the lumbar knob.







7. Align and install the lumbar knob.







8. Install the recliner handle and install the screw.







9. Install the recliner handle cover.







10. Connect the 6-way power seat switch electrical connector.
11. Install the affected seat and repower the SRS.