Oil Change Reminder Lamp: Service and Repair

Driver Controls

Setup Menu

Press this control for the following displays:






- System Check
- Units (English/Metric)
- Autolock
- Easy Entry/Exit
- Autolamp Delay
- Oil change
- Language
- Rear Park Assist (while in reverse)
- AWD Locked (if equipped)
- Avdtrac (if equipped)


System Check






Selecting this function from the SETUP menu causes the message center to cycle through each of the systems being monitored. For each of the monitored systems, the message center will indicate either an OK message or a warning message for three seconds.

Pressing the RESET control cycles the message center through each of the systems being monitored.

The sequence of the system check report and how it appears in the message center is as follows:

1. FUEL LEVEL (if low)
2. WASHER FLUID LEVEL
3. OIL LIFE IN XX%
4. ADVANCE TRAC (if equipped)
5. PARK ASSIST
6. ENGINE TEMP
7. OIL PRESSURE
8. TIRE PRESSURE SYSTEM
9. BRAKE FLUID LEVEL
10. CHARGING SYSTEM

Every 180 days or 8,000 km (50,000 miles) the oil life display in the message center SYSTEM CHECKS will decrease gradually from 100% TO 0%. At 5% oil life, the CHANGE OIL SOON warning message will display. At 0% oil life, the OIL CHANGE REQUIRED warning message will display. Oil life status is continually displayed in the SYSTEM CHECK portion of the message center and oil life warnings appear if oil life is low. To reset oil life message at oil change intervals, press and hold the RESET switch. For additional information, refer to the owner Literature.

Units (English/Metric)






1. Select this function from the SETUP menu for the current units to be displayed.
2. Press the RESET control to change from English to Metric.

Autolocks






1. Select this function from the SETUP control for the current display mode.
2. Press the RESET control to turn the autolocks ON or OFF.

Easy entry/exit






1. Select this function from the SETUP control for the current display mode.
2. Press the RESET control to turn the easy entry/exit ON or OFF.

Autolamp delay






1. Select this function from the SETUP control for the current display mode.
2. Press the RESET control to select the autolamp delay time.

Oil Change






1. Select this function from the SETUP control for the current display mode.
2. Press the RESET control to reset oil change.