Removal

P313 HYBRID TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE: REMOVAL

1. PRECAUTION

Service Precautions

2. REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY

HINT
Refer to the procedure up to Remove Instrument Panel Reinforcement Assembly with Air Conditioning Unit Assembly Removal.

3. REMOVE NO. 1 ENGINE UNDER COVER

4. DRAIN COOLANT (for Inverter) Service and Repair

5. REMOVE BATTERY SERVICE HOLE COVER Removal

6. REMOVE SERVICE PLUG GRIP Removal

7. REMOVE INTAKE AIR RESONATOR SUB-ASSEMBLY Removal

8. REMOVE INLET NO. 2 AIR CLEANER Removal

9. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

10. REMOVE INLET NO. 1 AIR CLEANER Removal

11. REMOVE AIR CLEANER ASSEMBLY WITH HOSE Removal

12. REMOVE NO. 3 INVERTER BRACKET Removal

13. REMOVE INVERTER RESERVE TANK ASSEMBLY Removal

14. REMOVE NO. 1 INVERTER RESERVE TANK BRACKET Removal

15. REMOVE INVERTER TERMINAL COVER Removal

16. CHECK TERMINAL VOLTAGE Removal

17. DISCONNECT NO. 4 ENGINE WIRE Removal

18. DISCONNECT NO. 3 WIRE FRAME (for AWD) Removal

19. DISCONNECT HIGH VOLTAGE CABLE OF FRONT MOTOR Removal

20. DISCONNECT NO. 3 WIRE FRAME Removal

21. INSTALL INVERTER TERMINAL COVER Removal

22. SEPARATE RELAY BLOCK SUB-ASSEMBLY Removal

23. DISCONNECT MG ECU CONNECTOR Removal

24. DISCONNECT WATER HOSE Removal

25. DISCONNECT NO. 2 ENGINE ROOM WIRE Removal

26. REMOVE NO. 4 INVERTER BRACKET Removal

27. SEPARATE RADIATOR RESERVE TANK ASSEMBLY Removal

28. SEPARATE CONDENSER Removal

29. REMOVE INVERTER WITH CONVERTER ASSEMBLY Removal

30. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Remove the nut from the control shaft lever.





(b) Using a screwdriver, disengage the 4 claws and disconnect the control cable with clip from the control cable bracket.

(c) Remove the clip.

(d) Disconnect the transmission control cable assembly from the 3 control cable brackets.





(e) Turn back the carpet.





(f) Remove the 3 bolts and pull out the transmission control cable assembly from the body.