Installation

P310 HYBRID TRANSMISSION / TRANSAXLE: TRANSAXLE CONTROL CABLE ASSEMBLY:

INSTALLATION

1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY






(a) Pull in the control cable to the body.
Install the 3 bolts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
2. INSTALL AIR BAG SENSOR ASSEMBLY CENTER Installation

3. INSTALL AIR DUCT REAR NO.2
4. INSTALL AIR DUCT REAR NO.1
5. INSTALL CONSOLE BOX DUCT NO.1
6. INSTALL SHIFT LEVER

7. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) In the cabin
(1) Connect the socket of the transmission control cable assembly to the shift lever assembly.





(2) Turn the socket of the transmission control cable assembly clockwise and install the stopper cap.
NOTE: Make sure that the transmission control cable assembly (socket) is firmly secured to the shift lever assembly.





(3) Push the stopper cap to the socket as shown in the illustration.





(4) Connect the control cable end to the shift lever assembly.
- Install the transmission control cable assembly with the graduated cuts to face upward to prevent torsion of the inner cable.
- Push the cable end to the bottom of the pin.
- Confirm that the connection between the socket and the shift lock control unit is fixed.

(b) Move the shift lever to the N position.
(c) In the engine compartment





(1) Connect the control cable to the control cable clamp.
(d) Move the control shaft lever to the N position.
(e) Install a new clip to the control bracket.






(f) Install the control cable to the control bracket.
- Make sure that the A claws on the clip are securely fit into the bracket holes.
- Make sure that the cable is securely installed inside of the B claws of the clip.





(g) Temporarily install the control cable to the control shaft lever with the nut.






(h) Lightly push up the control cable end.
NOTE: Do not push the control cable end excessively.

(i) Release your hand from the control cable end and then fully tighten the nut.
Torque: 15 Nm (150 kgf-cm, 11 ft-lbf)
8. INSTALL CONSOLE COVER LOWER Installation

9. INSTALL CONSOLE BOX ASSEMBLY Installation

10. INSTALL CONSOLE BOX HOLE COVER NO.2 Installation

11. INSTALL CONSOLE BOX HOLE COVER Removal

12. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER Installation

13. INSTALL FLOOR CARPET COVER CENTER RH Installation

14. INSTALL FLOOR CARPET COVER CENTER LH Installation

15. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

16. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.2 Installation

17. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

18. INSTALL FRONT DOOR SCUFF PLATE LH Installation

19. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER Installation

20. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH Installation

21. INSTALL FRONT DOOR SCUFF PLATE RH Installation

22. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER Installation

23. INSTALL CONSOLE PANEL UPPER FRONT Installation

24. INSTALL SHIFT LEVER KNOB

25. INSTALL INTAKE AIR SURGE TANK Installation

26. INSTALL EMISSION CONTROL VALVE SET Installation

27. INSTALL INVERTER BRACKET NO.1 Installation

28. INSTALL W/CONVERTER INVERTER ASSEMBLY
Installation
29. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.