Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: REMOVAL

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. OPEN BACK DOOR Removal

2. REMOVE ENGINE ROOM SIDE COVER LH
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
- w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE REAR NO. 2 SEAT ASSEMBLY LH
(a) Remove the rear no. 2 seat assembly Removal.
5. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE Removal

6. REMOVE REAR STEP COVER Removal

7. REMOVE REAR DOOR SCUFF PLATE LH Removal

8. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Removal

9. REMOVE REAR SEAT COVER CAP (for Semi Power Seat) Removal

10. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH Removal

11. REMOVE REAR AIRBAG SENSOR






(a) Remove the bolt and rear airbag sensor.
(b) Disconnect the connector.