Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: INSTALLATION

HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL REAR AIRBAG SENSOR






(a) Check that the engine switch is off.
(b) Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
- w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

(c) Install the rear airbag sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
- If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the rear airbag sensor.
(e) Connect the connector.
2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH Installation

3. INSTALL REAR SEAT COVER CAP (for Semi Power Seat) Installation

4. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Installation

5. INSTALL REAR DOOR SCUFF PLATE LH Installation

6. INSTALL REAR STEP COVER Installation

7. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE Installation

8. INSTALL REAR NO. 2 SEAT ASSEMBLY LH
(a) Install the rear No. 2 seat assembly Installation.
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. INSTALL ENGINE ROOM SIDE COVER LH Installation

11. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.