Removal

BRAKE SYSTEM (OTHER): BRAKE PEDAL: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FRONT DOOR SCUFF PLATE LH Removal

3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

4. REMOVE COWL SIDE TRIM BOARD LH Removal

5. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Removal

6. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY Removal

7. REMOVE PUSH ROD PIN






(a) Remove the clip and push rod pin from the brake pedal lever.
8. REMOVE STOP LIGHT SWITCH ASSEMBLY
(a) Disconnect the stop light switch connector.
(b) Remove the stop light switch Removal.
9. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY






(a) Remove the brake pedal support reinforcement set bolt.






(b) Remove the 4 nuts and brake pedal support assembly.