Front Disc Brake Caliper Anchor Plate

Brake Caliper Anchor Plate
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1 Raise and support the vehicle.
2 Remove the front wheel and tire.
For additional information, refer to Wheel and Tire Service and Repair









Torque to: 28 Nm

CAUTION: Do not allow the brake caliper to hang on the brake hose.
3 Release the brake caliper.









CAUTION: Make sure that new bolts are installed.

Torque to: 200 Nm

Installation

CAUTION: Make sure that the brake hose is not twisted and is correctly located.
1 To install, reverse the removal procedure.