Brake Pedal - Vehicles With: Automatic Transmission
Brake Pedal - Vehicles With: Automatic TransmissionService Repair No - 70.35.01
Removal
1. Remove the headlamp switch.
2. Remove the stoplamp switch.
3. Remove the instrument panel access panel.
^ Release the 2 clips.
4. Remove the brake pedal bracket.
^ Release the wiring harness clip.
^ Remove the 4 Torx bolts.
5. Remove the brake pedal clevis pin.
^ Remove the clip.
6. Remove the brake pedal.
^ Remove the nut and bolt.
NOTE: Do not disassemble further if the component is removed for access only.
7. Remove the brake pedal pad.
Installation
1. Install the brake pedal pad.
2. Install the brake pedal.
^ Clean the component mating faces.
^ Tighten the nut and bolt to 45 Nm (33 ft. lbs.).
3. Install the brake pedal clevis pin.
^ Install the clip.
4. Install the brake pedal bracket.
^ Tighten the Torx bolts to 10 Nm (7 ft. lbs.).
^ Secure the wiring harness.
5. Install the instrument panel access panel.
^ Secure with the clips.
6. Install the stoplamp switch.
7. Install the headlamp switch.