Engine Accessory Bracket: Service and Repair

Accessory Drive Component Bracket

Special Service Tools





Removal

NOTE: It is only necessary to check the alignment of the bracket if the bracket has been replaced, or any of the components it mounts to have been adjusted or replaced.

1. Remove the cover and disconnect the battery ground cable.
2. Remove the engine cover.
3. Remove the battery tray.
4. Remove the air cleaner assembly.
5. Remove the A/C compressor, upper support bracket.





6. Remove the A/C compressor, lower support bracket.





7. Release the accessory drive belt tension.





8. Release the A/C compressor and tie aside.





9. Remove the accessory drive component bracket.





10. NOTE: Do not disassemble further if the component is removed for access only.

Remove the dowels.

Installation

1. Install the dowels.

2. NOTE: It is only necessary to check the alignment of the bracket if the bracket has been replaced, or any of the components it mounts to have been adjusted or replaced.

Check the alignment of the bracket using the special tool.
Special Service Tools: Aligner, A/C Bracket





3. Install the accessory drive component bracket.

Torque:
M10. 50 Nm
M8. 24 Nm

4. Install the A/C compressor.

Torque:
25 Nm

5. Install the accessory drive belt.
6. Install the A/C compressor, lower support bracket.

Torque:
25 Nm

7. Install the A/C compressor, upper support bracket.

Torque:
M10. 45 Nm
M8. 25 Nm
M6. 10 Nm

8. Install the air cleaner assembly.
9. Install the battery tray.
10. Install the engine cover.
11. Connect the battery ground cable and install the cover.