Front Bumper Cover

Front Bumper Cover

Service Repair No - 76.22.72

Removal

1. Remove the radiator grille.
2. Release the front bumper cover from the fender splash shield.
^ Remove the screw.
^ Repeat the above procedure for the other side.







3. Remove the towing eye cover.
^ Release the 2 clips.

4. Release the front bumper cover from the radiator splash shield.
^ Remove the 6 screws.







5. Release the front bumper cover from the front bumper armature.
^ Remove the 2 covers.
^ Remove the 2 screws.







6. Release the front bumper cover from the headlamp support bracket.
^ Remove the 4 screws.







7. Release the front bumper cover from the front fenders.
^ Release from the 2 clips.







8. With assistance, remove the front bumper cover.
^ Disconnect the 6 electrical connectors.
^ Release the clip and disconnect the washer jet hose.







9. NOTE: Do not disassemble further if the component is removed for access only.

If installed, remove the license plate.

10. If installed, remove the license plate panel.
^ Remove the 5 screws.

11. Remove the front fog lamp bezel.
^ Release the 5 clips.
^ Repeat the above procedure for the other side.







12. Remove the front fog lamp.
^ Remove the 3 screws.
^ Repeat the above procedure for the other side.







13. Remove the parking aid sensor.
^ Release from the 2 clips.
^ Repeat the above procedure for the remaining 3 sensors.







14. Remove the headlamp washer jet.
^ Remove the clip.
^ Disconnect the washer jet hose.
^ Repeat the above procedure for the other side.







15. Remove the headlamp washer jet hose.
^ Release from the 5 clips.







16. Remove the front bumper trim panel.
^ Remove the 2 screws.
^ Release the 2 clips.
^ Repeat the above procedure for the other side.







Installation

1. Install the front bumper trim panels.
^ Secure the clips.
^ Tighten the screws.

2. Install the headlamp washer jet hose.
^ Secure with the clips.

3. Install the headlamp washer jets.
^ Connect the washer jet hose.
^ Install the clips.

4. Install the parking aid sensors.
^ Secure with the clips.

5. Install the front fog lamps.
^ Tighten the screws.

6. Install the front fog lamp bezels.
^ Secure the clips.

7. If installed, install the license plate panel.
^ Tighten the screws.

8. If installed, install the license plate.
^ Clean the components.

9. Install the towing eye cover.
^ Secure the clips.

10. With assistance, install the front bumper cover.
^ Connect the washer jet hose and secure with the clip.
^ Connect the electrical connectors.
^ Secure the clips.
^ Tighten the screws.
^ Install the screw covers.

11. Install the radiator grille.