A-Pillar Trim Panel

A-Pillar Trim Panel

Service Repair No - 76.13.26

Removal

1. Disconnect the battery ground cable.
2. Make the SRS system safe.
3. Release sufficient door aperture seal for access.
4. Release the screw cover.
^ Remove the Torx screw.

5. WARNING: The air bag is mounted directly under this component, extreme care is necessary.

Remove the A-pillar upper trim panel.
^ Carefully release the 2 clips.







6. NOTE: Do not disassemble further if the component is removed for access only.

Remove the 2 clips.

Installation

1. Install the clips.
2. Install the A-pillar upper trim panel.
^ Secure the clips.
^ Tighten the Torx screw to 2 Nm (1.5 ft. lbs.).
^ Install the screw cover.
^ Install the aperture seal.

3. Connect the battery ground cable.