Front Suspension

60.10.02 Link - anti roll bar
Road wheels must be in straight ahead position during this operation

Remove
1. Raise front of vehicle.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.





2. Remove road wheel.
3. Remove nut securing anti-roll bar link to anti-roll bar.

CAUTION: Use an open ended spanner on flats provided to prevent ball joint rotating.





4. Release link from anti-roll bar.
5. Remove nut securing anti-roll bar link to damper.
6. Remove link and collect washer fitted to top ball joint.

CAUTION: Note position of washer for refit.

Refit
1. Fit washer to ball joint, fit anti-roll bar link, fit nuts and tighten to 100 Nm (74 ft. lbs.).

CAUTION: The washer is hardened and must be fitted in the correct position.

2. Fit road wheel and tighten nuts to 140 Nm (103 ft. lbs.).
3. Remove stands and lower vehicle.