With ABS

FRONT HUB ABS

Overhaul

1. Remove front hub assembly ABS. Refer to With ABS
2. Remove outer bearing.
3. Mark, for reassembly, relationship between hub and brake disc, if original hub is to be refitted.
4. Remove five bolts and separate hub from brake disc.
5. Drift out grease seal and inner bearing from hub and discard seal.






6. Drift out inner and outer bearing tracks.
7. Clean hub and drift in inner and outer bearing tracks.
8. Pack hub inner bearing with recommended grease and fit to hub.






9. With lip side leading fit new seal to hub using special tool LST 137 seal replacer and drift 18G134. Drive in seal flush with rear face of hub. Apply grease between seal lips.
10. Fit brake disc to hub, lining up to marks made during dismantling. Applying Loctite 270©, fit and tighten five retaining bolts to 73 Nm.
11. Grease and fit outer bearing to hub.
12. Fit front hub assembly. Refer to With ABS