216RBI

REAR AXLE - 216FBI

COVER - DIFFERENTIAL

REMOVAL
1. With vehicle in neutral, position vehicle on hoist.
2. Remove drain plug.

Fig. 37 INDICATOR SWITCH CONNECTOR:

3. If equipped with Tru-Lok, disconnect indicator switch harness and remove connector from differential cover (Fig. 37).
4. Remove cover bolts.
5. Remove cover and drain lubricant.

INSTALLATION

Fig. 38 HOUSING COVER - TYPICAL:

1. Apply a 6.35 mm (1/4 inch) bead of Mopar Silicone Rubber Sealant or equivalent to the housing cover (Fig. 38).

CAUTION: If housing cover is not installed within 3 to 5 minutes, the cover must be cleaned and new RTV applied. Failure to heed caution may result in damage.

Fig. 39 INDICATOR SWITCH CONNECTOR:

2. Install cover, identification tag and indicator switch connector if equipped with Tru-Lok (Fig. 39). Tighten cover bolts in a criss-cross pattern to 41 Nm (30 ft. lbs.).
3. Connect indicator switch harness if equipped with Tru-Lok.
4. Fill differential to specifications.
5. Install fill plug and tighten to 34 Nm (25 ft. lbs.).