Air Outlets

AIR OUTLETS

REMOVAL

NOTE: The instrument panel air outlets are retained to the pivots within the air outlet housings by a snap fit.

Instrument Panel Air Outlets:

1. Using a trim stick C-4755 or equivalent, gently pry the panel air outlet out of the panel outlet housing as required.

INSTALLATION

CAUTION: The instrument panel air outlets can only be installed in one direction. If an air outlet is not properly oriented prior to installation, damage to the outlet will occur.

NOTE: Each air outlet is retained into the outlet opening by two pivot shafts. One pivot shaft is larger than the other. The air outlet must be first installed onto the larger pivot shaft, then snapped into place over the smaller pivot shaft.

1. Install the air outlet onto the larger pivot shaft located in the instrument panel outlet opening.
2. Gently push the air outlet onto the smaller pivot shaft until it snaps into position.