Outside Rearview Mirror Glass

MIRROR GLASS-OUTSIDE REARVIEW

REMOVAL

WARNING: Always wear eye and hand protection when servicing the mirror glass. Failure to observe these warnings may result in personal injury from broken glass.

1. Position the mirror glass (1) so that it is facing in toward the vehicle as far as possible.
2. Disconnect and isolate the negative battery cable.
3. Using a trim stick C-4755 or equivalent flat bladed tool (2), pry out mirror glass.
4. Separate the mirror glass and disconnect the mirror wire harness from the heated glass electrical connector, if equipped.

INSTALLATION

1. Connect the mirror wire harness to the heated glass electrical connector, if equipped.

NOTE: Pressure must be applied equally over the center portion of the mirror glass to fully engage the mirror glass retaining clips to the mirror motor.

2. Using one hand, carefully push the mirror glass holder onto the mirror motor, while at the same time supporting the mirror housing from the backside with the other hand. Firmly push on the mirror glass holder until all mirror glass retaining clips are fully engaged.
3. Verify retention of the mirror glass holder by gently pulling outward on the glass.
4. Reconnect the negative battery cable.