Removal and Installation
1984-87 QUADRA-TRAC1. Raise and support vehicle and drain lubricant from transfer case.
2. Disconnect speedometer cable and vent hose, then the transfer case shift lever link at the operating lever.
3. Place suitable support under transmission and remove rear crossmember.
4. Scribe alignment marks on transfer case front and rear output shafts at transfer case yokes and propeller shafts for proper assembly.
5. Disconnect front and rear propeller shafts at transfer case yokes and secure shafts out of way.
6. Disconnect shift motor vacuum hoses and the transfer case shift linkage.
7. Remove transfer case to transmission attaching bolts.
8. Move transfer case rearward until clear of transmission output shaft and remove assembly.
9. Remove all gasket material from rear of transmission adapter housing.
10. Reverse procedure to install.