Evaporative Emission Control Canister: Service and Repair

Removal
1. Disconnect battery ground cable.

WARNING: BEFORE PROCEEDING, IT IS ESSENTIAL THAT THE WARNING NOTES GIVEN ARE READ AND UNDERSTOOD.

2. Raise vehicle on four post ramp.





3. Disconnect inlet and outlet pipe adapter elbow.

NOTE: Discard O-ring seals from adapter elbows.





4. Remove EVAP canister assembly from body.
Remove front mounting bolts.





5. Remove rear mounting bolt.
6. Remove EVAP canister.


Installation

Installation is the reverse of the removal procedure.

NOTE: Install new O-ring seals to adapter elbows and apply suitable lubrication.

Tighten front and rear mounting bolts to 9 - 12 Nm.