Front

REMOVE
- Remove the air cleaner assembly.
- Remove the nuts from above and below the rubber mounting pads on both sides of the engine.
- Carefully raise the engine, using a trolley jack with a wooden block between the jack head and the oil pan to release the weight from the mountings.

NOTE: Avoid fouling the fan and cowl.

- Remove the bolts securing the mounting brackets to the engine and withdraw the mounting brackets.
- Collect the packing pieces and lift out the rubber mountings.

REFIT
- Place replacement mountings in position on the chassis brackets.
- Replace the spring washers and nuts; tighten the nuts by hand only.
- Replace the mounting brackets on the engine, fitting new insulator pads between the brackets and rubber mountings.
- Replace the plain washer and Cleveloc nuts, but do not tighten the nuts; lower the jack.
- Tighten the attachment bolts and nuts at the brackets to the correct torque and finally tighten the mounting nuts.
- Replace the air cleaner.