Removal and Replacement

BRAKE PEDAL


Removal and Installation


REMOVAL
1. Remove instrument lower panel LH. Refer to Exploded View.
2. Remove steering column assembly. Refer to Exploded View(without electric motor), Exploded View (with electric motor).
3. Disconnect the stop lamp switch and ASCD brake switch harness connectors.
4. Disconnect the brake pedal stroke sensor harness connector. (With pre-crash seat belt)

CAUTION:
Never removing brake pedal stroke sensor. (With pre-crash seat belt)
5. Turn the stop lamp switch counterclockwise to remove the stop lamp switch.
6. Loosen the lock nut for the ASCD brake switch and remove the ASCD brake switch.
7. Remove snap pin and clevis pin from clevis of brake booster.
8. Remove the cowl top. Refer to Exploded View.
9. Remove the instrument panel. Refer to Exploded View.
10. Slide the steering member rearward. Refer to Exploded View.
11. Remove the brake pedal assembly.

INSTALLATION
Note the following, and installation in the reverse order of removal.
- Apply the multi-purpose grease to the clevis pin and the mating faces. (Not necessary if grease has been already applied)

NOTE:
The clevis pin may be inserted in either direction.