Front

Fig. 2 Brake Pad Removal:

1. Raise and support vehicle, then remove master cylinder cap.
2. Disconnect speed sensor connector.
3. Remove lower caliper mounting pin/bolt.
4. Pivot caliper upwards, then remove pad retainers and inner and outer shims, Fig. 1.
5. Remove brake pad wear sensor. Replace brake pad sensor with a new one when brake pads are replaced. Testing and Inspection
6. Remove brake pads.
7. Compress caliper piston with suitable C-clamp.
8. Reverse procedure to install. Tighten to specifications and bleed brake system as described under Brakes.