Removal and Installation

PARKING BRAKE CONTROL


Removal and Installation


REMOVAL
1. Remove rear tires with power tool.
2. Remove instrument lower panel LH. Refer to Exploded View.
3. Disconnect parking brake switch harness connector.
4. Remove adjusting nut and loosen front cable.
5. Remove device assembly.
6. Remove center console. Refer to Exploded View.
7. Remove rear ventilator duct (with rear ventilation). Refer to Exploded View.
8. Remove the center muffler and heat insulator. Refer to Exploded View.
9. Separate front cable from rear cable, and remove front cable and spring.
10. Remove parking brake shoe, and remove rear cable from toggle lever. Refer to Parking Brake Shoe.
11. Remove rear cable mounting bolts and nuts, pull out rear cable from vehicle.

INSTALLATION
Install in the reverse order of the removal.