Rear Seat Belt

Replacement

Rear Seat Belt Replacement

CAUTION:
- When installing the belt, make sure not to damage the retractor.

1. Remove the following items first :
A. Rear seat assembly

B. Front door scuff trim [LH]

C. Rear door scuff trim [RH]

2. Using a screwdriver or remover, remove the rear transverse trim (A).




3. After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
[LH, RH]

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




4. Using a screwdriver or remover, remove the center pillar lower trim (A).
[LH]




5. Using a screwdriver or remover, remove the luggage side trim lamp (A).
6. Disconnect the luggage side trim lamp connector (B).
7. After loosening the mounting screws, then remove the luggage side trim (C).
[LH]




[RH]




8. After loosening the mounting bolt, then remove the rear seat belt (A) and rear seat belt retractor (B).

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




9. Installation is the reverse of removal.

NOTE:
- Make sure the connector is plugged in properly.
- Replace any damage clips.

Rear Seat Belt Buckle Replacement
1. Remove the following items first :
A. Rear seat cushion assembly

2. After loosening the mounting bolt, then remove the rear seat belt buckle (A).
[LH]

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




[RH]

Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)




3. Installation is the reverse of removal.