Water Pipe

Water pipe

Removal

1. Remove the intake manifold module.
2. Remove the water outlet pipe (A) and the water inlet pipe (B).





NOTE:
Remove the drain plug (A) and drain the engine coolant.





Installation

1. Install the O-ring to the water pipes.

NOTE:
- Use new O-rings when reassembling.
- Never apply sort of oil on O-ring and O-ring groove of pipe end.
- O-ring must be free from scratching damage.

2. Install the water outlet pipe (A) and the water inlet pipe (B).

Tightening torque :
9.8 - 11.8Nm (1.0 - 1.2kgf.m, 7.2 - 8.7lb-ft)


NOTE:
- Make clean the contact face before assembly.
- Insert pipe after to be wetting O-ring or inside of attaching hole by water or antifreeze.





NOTE:
Install the drain plug (A).

Tightening torque :
96.1 - 100.0N.m(9.8 - 10.2kgf.m,70.9 - 73.8lb-ft)





3. Install the intake manifold module.