Removal/Instalation

REMOVAL
1. Drain the power steering fluid.




2. Disconnect the pressure hose and the return tube.
3. Remove the joint assembly connecting bolt.




4. Using the special tool (09568 - 31000), disconnect the tie rod end from the knuckle arm.




5. Remove the center member assembly with front roll stopper.




6. Disconnect the front muffler temporarily.




7. Remove the stay and disconnect the left lower arm.




8. Remove the stabilizer bar.




9. Remove the steering gear box mounting brackets and remove the steering gear box assembly together with mounting rubber.

NOTE: Move the rack completely to the right and then remove the gear box to the left from the crossmember.

CAUTION: When removing the gear box, pull it out carefully and slowly to avoid damaging the boots.




INSTALLATION
1. When installing the mounting rubber, align the projection of the mounting rubber with the indentation in the crossmember to install the gear box.
2. Confirm that there is no oil leak.
3. Confirm that the steering wheel rotates smoothly when it is turned.
4. Adjust the toe-in.
5. Install the parts by reference to torque specifications.