Overhaul

SERVICE SPECIFICATIONS
End Play:
Low Reverse Brake 0.975-1.287 mm (0.038-0.051 inch)
Transfer Drive Gear 0-0.06 mm (0-0.0024 inch)
Transfer Shaft:
(Without Pre-load) 0.01-0.06 mm (0.0004-0.0024 inch)

TIGHTENING SPECIFICATIONS
Adjust Screw:
Nut Size M10-4T 1.5-2.2 kg.m (11-16 ft. lbs.)
Bearing Retainer To Rear Cover:
Machine Screw Size M8-7T 1.7-2.2 kg.m (12-16 ft. lbs.)
Clamp To Case:
Bolt Size M8-4T 0.8-1.0 kg.m (72-84 inch lbs.)
Drain:
Plug Size M14-4T 3.5-4.5 kg.m (25-32 ft. lbs.)
Jet To Lower Separating Plate:
Nut Size M5-4T 0.15-0.25 kg.m (12-24 inch lbs.)
Pressure Check:
Plug Size M8-4T 0.8-1.0 kg.m (72-84 inch lbs.)
Pulse Generator To Case:
Flange Bolt Size M6-7T 1.0-1.2 kg.m (84-108 inch lbs.)
Rear Plate:
Bolt Size M6-7T 0.8-1.0 kg.m (72-84 inch lbs.)
Reaction Shaft Support Assembly To Oil Pump Housing Assembly:
Flange Bolt Size M6-7T 1.0-1.2 kg.m (84-108 inch lbs.)
Sprag Rod Support To Case:
Flange Bolt Size M8-7T 2.0-2.7 kg.m (14-19 ft. lbs.)
Transfer Shaft To Transfer Driven Gear:
Nut Size M24-7T 20.0-23.0 kg.m (143-165 ft. lbs.)
Transmission To Engine:
Flange bolt Size M10-7T 4.6-5.3 kg.m (33-38 ft. lbs.)