Drive Belt: Service and Repair

REMOVAL
1. Loosen the coolant pump pulley bolts
2. Loosen the generator support nut.
3. Looses the generator lock bolt, and remove the belt.
4. Remove the coolant pump pulley bolts.

INSTALLATION
1. Install the coolant pump pulley to the coolant pump pulley bracket and tighten the bolts firmly.
2. After installing the belt, adjust the belt tension.
Tightening torque:
Generator support nut A: 20-25 Nm (200-250 kg. cm., 14-18 ft. lbs.).
Generator lock bolt B: 15-22 Nm (150-220 kg. cm., 11-16 ft. lbs.).
Generator brace mounting bolt: 20-28 Nm (200-280 kg. cm., 14-20 ft. lbs.).
Coolant pulley bolts: 8-10 Nm (80-100 kg. cm., 6-7 ft. lbs.).