Removal/Instalation

1. Raise and support vehicle.
2. Drain power steering fluid, then disconnect pressure hose and return tube.
3. Disconnect joint coupling from steering gear.
4. Using tie rod end puller tool No. 09568-31000, or equivalent disconnect tie rod end from knuckle arm.
5. On Mando type steering gear, remove center member and tighten front muffler assembly.
6. On TRW type steering gear, remove center member assembly with front roll stopper.
7. Disconnect front exhaust pipe from engine, then remove stay and disconnect left lower arm.
8. Remove stabilizer bar, then the steering gearbox mounting brackets.
9. Remove steering gearbox assembly together with mounting rubber. Move rack to the right, then remove steering gear from crossmember
10. Reverse procedure to install.