Parking Brake Pedal: Service and Repair

Parking Brake Pedal

Removal

1. Disconnect the parking brake switch connector(A).




2. Remove the mounting clip(B), then remove the parking brake cable(C).
3. Remove the parking brake pedal mounting bolts and nut(D), then remove the parking brake pedal.
4. Remove the floor console. .
5. Remove the floor carpet.
6. Remove the parking brake cable(A).






Installation

1. Install the parking brake cable(A).




2. Install the floor carpet.
3. Install the floor console. .
4. Install the parking brake pedal , and then install the parking brake pedal mounting bolts and nut(D).




5. Install the parking brake cable(C) , and then install the mounting clip(B).
6. Adjust the parking brake pedal stroke by turning the adjusting nut(A).
(1) Adjust the adjusting nut(A) so that parking brake pedal stroke is to be 88 - 98mm (3.46 - 3.86in) when operating effort is 196 N(20 kgf, 44 lb) after full stroke operation of parking brake pedal over 3 times for setting parking wire.





NOTE:
1. The parking brake adjustment must be carried out after adjusting the rear shoe.
2. After adjusting parking brake, notice following matter.
1) Must be free from clearance between adjusting nut and pin.
2) Check securely that the brake is not dragging.

7. Reconnect the parking brake switch connector(A).