Stabilizer Bushing: Service and Repair

Rear Stabilizer Bushing Replacement

1. Raise the vehicle on a lift. Service and Repair

2. Remove the stabilizer bushing (A) from the axle beam.

3. Apply silicone spray (P/N 08209-0001) to the new stabilizer bushing. This will ease installation of the bushing into the stabilizer and the axle beam.






4. Install the stabilizer bushing (A) into the axle beam by aligning the end face of the stabilizer bushing to the center of hole (B).
NOTE:

- Securely install the stabilizer (C) into the stabilizer bushing groove (D).

- Make sure the stabilizer bushing is not protrusion the end of the axle beam (E).