Parking Brake System: Adjustments

Parking Brake Inspection and Adjustment

Inspection

1. Pull the parking brake lever (A) with 196 N (20 kgf, 44 lbf) of force to fully apply the parking brake. The parking brake lever should be locked within the specified number of clicks.





2. If the number of lever clicks is not as specified, adjust the parking brake.

Adjustment

1. Release the parking brake lever fully.
2. Pull out the center console rear trim (A).





3. Loosen the parking brake adjusting nut (B).
4. Raise the rear of the vehicle, and support it with safety stands in the proper locations.
5. Remove the rear wheels.
6. Make sure the parking brake lever (A) on the rear brake caliper contacts the arm (B).

NOTE: The parking brake lever will contact the arm when the parking brake adjusting nut is loosened.





7. Clean the mating surfaces of the brake disc and the inside of the wheel, then install the rear wheels.
8. Pull the parking brake lever 1 click.
9. Tighten the parking brake adjusting nut until the parking brakes drag slightly when the rear wheels are turned.
10. Release the parking brake lever fully, and check that the parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
11. Make sure the parking brake lever within the specified number of clicks (7 to 9 clicks).
12. Install the center console rear trim.