Steering Column Lock: Service and Repair

1. On models equipped with airbag, disarm airbag as described under Air Bags and Seat Belts / Air Bags (Supplemental Restraint Systems / Airbag System Disarming).
2. Disconnect battery ground cable.
3. Remove lower steering column cover.
4. Disconnect ignition switch connector.
5. Center punch each of the two shear screw heads, then using a suitable drill and drill bit, remove screw heads and the switch.
6. Install new switch without ignition key inserted.
7. Hand tighten shear screws, insert ignition key, and check for proper operation of wheel lock.
8. Tighten shear screws until hex heads twist off.
9. Reconnect switch connector.
10. Position switch wiring and install lower steering column cover.
11. Rearm airbag, if equipped.