Technician Safety Information

TECHNICIAN SAFETY INFORMATION

- Carefully inspect any SRS part before you install it. Do not install any part that shows signs of being dropped or improperly handled, such as dents, cracks or deformation:
- Airbag assembly (driver's and front Passengers, Dash sensors.
- Cable reel.
- SRS unit.
- Use only a digital multimeter (KS-HAM-32-003) to check the system. Using an analog circuit tester may cause an accidental deployment and possible injury.
- Do not install used SRS parts from another car. When making SRS repairs, use only new parts.
- Except when performing electrical inspections, always disconnect both the negative cable and positive cable at the battery before beginning work.
- Replacement of the combination light and wiper/washer switches and cruise control switch can be done without removing the steering wheel.
- Do not try to disassemble the airbag assembly. It has no serviceable parts. Once an airbag has been operated (deployed), it cannot be repaired or reused.
- For temporary storage of the airbag assembly during service, please observe the following precautions:
- Store the removed airbag assembly with the pad surface up.





WARNING:
- If the airbag is improperly stored face down, accidental deployment could propel the unit with enough force to cause serious injury.

CAUTION:
- Improper handling or storage can internally damage the airbag assembly, making it inoperative.
- If you suspect the airbag assembly has been damaged, install a new unit and refer to the Deployment/Disposal Procedures for scrapping of the damaged airbag.

WARNING:
- To avoid accidental deployment and possible injury, always install the protective short connectors on the driver's (and passenger's) airbag connector(s) before working near any SRS wiring.

1. Disconnect the battery negative cable, then disconnect the positive cable.
2. Install the short connector(s):

Drivers Side Short Connector Installation:

Driver's Side:
- Remove the access panel from the steering wheel, then remove the short connector (RED) from the panel.
- Disconnect the connector between the driver's airbag and cable reel, then install the short connector (RED) on the airbag side of the connector.

Passenger Side Air Bag Short Connector:

Front Passenger's Side (Sedan SE model):
- Remove the glove box.
- Disconnect the connector between the front passenger's airbag and SRS main harness, install the short connector (RED) on the airbag side of the connector.