Removal and Installation

For additional information see Removal and Installation Notes. Fundamentals and Basics

DX And LX:

DX and LX MODELS

LX-i And SE-i:

LX-i and SE-i Models

REMOVAL/INSTALLATION
1. Remove the banjo bolt and disconnect the brake hose from the caliper.

Caliper Removal And Installation:

2. Remove the caliper bolt, then remove the caliper.
3. Reinstall the caliper in the reverse order of removal.
4. Fill the brake reservoir up and bleed the brake system.

CAUTION:
- Make sure all parts are clean before reassembly.
- Use only new replacement parts.
- Use only clean brake fluid.
- Do not allow dirt or other foreign matter to contaminate the brake fluid.
- Do not mix different brands of brake fluid.
- Avoid spilling brake fluid on painted, plastic or rubber surfaces as it can damage the finish; Wash spilled brake fluid off immediately with clean water.