A/T Clutch Pressure Control Solenoid Valve B and C Replacement

A/T Clutch Pressure Control Solenoid Valve B and C Replacement
1. Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
2. Remove the splash shield.
3. Disconnect the connectors from A/T clutch pressure control solenoid valve B and C.





4. Remove A/T clutch pressure control solenoid valve B and C.
5. Remove the ATF joint pipes (A), O-rings (D), and gasket (E).
6. Clean the mounting surface and fluid passage of the solenoid valve body and transmission housing.
7. Install the new gasket on the transmission housing, and install the ATF joint pipes.
8. Install the new O-rings over the ATF joint pipes.
9. Install A/T clutch pressure control solenoid valve B and C.
10. Check the connectors for rust, dirt, or oil, then connect the connectors securely.
11. Install the splash shield.