Rear Bumper: Service and Repair

Rear Bumper Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014

NOTE:
- Have an assistant help you when removing and installing the rear bumper.
- Take care not to scratch the rear bumper and body.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
- Put on gloves to protect your hands.
- Apply protective tape around the hinge side edge of the tailgate lower trim to prevent damage to the rear bumper.
- Before removing the rear bumper, remove the bolt securing the body side end of the tailgate support strut. After removing the bolt, gently open or close the tailgate to allow maximum clearance between the rear bumper and the tailgate lower trim, and hold the tailgate in this position.

1. Remove the rear bumper as shown.




2. Install the bumper in the reverse order of removal, and note these items:
- Make sure the rear bumper engages the hooks of the side spacers and upper brackets on both sides securely.
- Replace the clip, if it's damaged.
- Push the clip into place securely.