Driver Side

1. Remove the driver's door panel, and disconnect all connectors




2. Disconnect the 4P connector from the window motor.




3. Test the motor in each direction by connecting battery power and ground according to the table. When the motor stops running, disconnect one lead immediately.
4. If the motor does not run at all or does not run smoothly, replace it.

Pulser Test:
5. Connect the test leads of an analog ohmmeter to the No.3 and No.4 terminals.
6. Run the motor by connecting power and ground to the No.1 and No.2 terminals. The ohmmeter needle should move back and forth alternately.