Tracker 2WD Manual Transmission
REMOVE OR DISCONNECT1. Raise and suitably support vehicle.
2. Support transmission with a suitable hydraulic jack.
3. One bolt and ground wire from speedometer driven gear case.
4. Temporarily install the speedometer driven gear case retaining bolt.
5. Two bolts from rear transmission mount.
6. Four bolts and rear transmission crossmember from vehicle.
7. One bolt and rear transmission mount from extension case.
INSTALL OR CONNECT
1. Rear transmission mount to extension case; secure with one bolt.
- Tighten rear transmission mount bolt to 60 Nm (44 ft. lbs.).
2. Rear transmission crossmember to vehicle; secure with four bolts.
- Tighten rear transmission crossmember bolts to 60 Nm (44 ft. lbs.).
3. Two bolts to rear transmission mount.
- Tighten rear transmission mount bolts to 60 Nm (44 ft. lbs.).
4. Remove the speedometer driven gear case retaining bolt.;
5. Ground wire to speedometer driven gear case; secure with one bolt.
- Tighten speedometer driven gear case retaining bolt to 12 Nm (106 inch lbs.).
6. Remove hydraulic jack from underneath transmission.
7. Lower vehicle.