Hydraulic Control Assembly - Antilock Brakes: Service and Repair

ABS Solenoid:

REMOVE OR DISCONNECT
1. Solenoid electrical connector.
2. Torx (R) head bolts.
3. Solenoid.
^ Be sure the seal is still attached to the solenoid when it is removed. If not, check solenoid bore in modulator.
^ Do not attempt to disassemble solenoid, it is serviceable only as an assembly.
^ Lubricate seal on new solenoid with clean brake fluid.

INSTALL OR CONNECT
1. New solenoid.
^ Verify that the solenoid lip seal is properly positioned before solenoid is installed in hydraulic modulator.
^ Position solenoid so that its electrical connector will face the same direction as the solenoid that was removed.
^ By hand, press down firmly on solenoid until its flange seats on ABS hydraulic modulator.
2. Torx (R) head bolts. Tighten to 5 Nm (44 inch lbs.).
3. Solenoid electrical connector to solenoid.
^ Make sure the solenoid connectors are installed on correct solenoids.
^ It is necessary to bleed hydraulic modulator. Service and Repair