Heating, Ventilation and Air Conditioning
Fastener Tightening Specifications| A/C Compressor Cycling Switch | 5 N.m |
| A/C Compressor Mounting Bolt | 50 N.m |
| A/C Compressor Rear Bracket Bolt | 25 N.m |
| A/C Evaporator and Blower Module Shield Screws | 2.2 N.m |
| A/C Refrigerant Pressure Sensor | 4.8 N.m |
| Accumulator Clamp Screw | 10 N.m |
| Accumulator to Evaporator Fitting | 28 N.m |
| Air Distributor Duct Mounting Screw | 1.9 Nm |
| Air Temperature Actuator Retaining Screw | 1.9 N.m |
| Air Inlet Assembly Mounting Stud | 4.5 N.m |
| Blower Assembly Mounting Nut (RPO C42) For a description of the RPO Code(s) shown in this specifications, refer to the RPO Code List found at Vehicle/Application ID". | 4.5 N.m |
| Blower Assembly Mounting Screw (RPO C42) For a description of the RPO Code(s) shown in this specifications, refer to the RPO Code List found at Vehicle/Application ID". | 4.5 N.m |
| Blower Assembly Mounting Stud (RPO C42) For a description of the RPO Code(s) shown in this specifications, refer to the RPO Code List found at Vehicle/Application ID". | 4.5 N.m |
| Blower Motor and Fan Assembly Mounting Screw | 1.9 N.m |
| Blower Motor Access Cover Screw (RPO C60 and C68) For a description of the RPO Code(s) shown in this specifications, refer to the RPO Code List found at Vehicle/Application ID". | 2.5 N.m |
| Blower Motor Relay Bracket Mounting Screw | 1.9 N.m |
| Blower Motor Resistor Mounting Screw | 1.9 N.m |
| Body Harness Connector Support Bracket Mounting Nuts | 9.0 N.m |
| Compressor Suction Hose to Accumulator Fitting | 48 N.m |
| Compressor Suction/Discharge Hose to Compressor Bolt | 33 N.m |
| Compressor Discharge Hose to Condenser Fitting | 28 N.m |
| Compressor Pressure Relief Valve | 9 N.m |
| Condenser Insulator Retaining Screw | 1.9 N.m |
| Evaporator Case Section to Blower Case Section Retaining Screw | 1.9 N.m |
| Evaporator Tube Clip Screw | 1.9 N.m |
| Evaporator Tube to Condenser Fitting | 28 N.m |
| Floor Air Outlet Mounting Screw | 1.9 N.m |
| Heater Core Access Cover Screw | 1.9 N.m |
| Heater Inlet Hose Fitting at Intake Manifold | 23.5 N.m |
| Heater Inlet and Outlet Hoses Bracket Bolt | 25 N.m |
| Heater Outlet Hose Bracket Bolt | 25 N.m |
| Heater/Vent Module Mounting Nut | 4.5 N.m |
| Heater/Vent Module Mounting Screw | 4.5 N.m |
| Heater/Vent Module Mounting Stud | 4.5 N.m |
| Intermediate Bracket Bolts | 10 N.m |
| Knee Bolster Bracket Nuts | 5.5 N.m |