Front Bumper Cover / Fascia: Service and Repair

BUMPER COVER - FRONT

Part 1:

Part 2:

Exploded View

Removal and Installation

1. WARNING:
- If equipped with fire suppression system, depower the system. For important safety warnings and procedures refer to Fire Suppression System.
- The electrical power to the air suspension system must be turned off prior to hoisting, jacking or towing an air suspension vehicle. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations. Failure to follow these instructions may result in personal injury.

With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the 4 lower radiator air deflector bolts and the 2 radiator vertical deflector bolts.
- To install, tighten to 7 Nm (62 lb-in).

3. Remove the 2 pin-type retainers (1 each side).
4. Remove the 6 front bumper cover pin-type retainers (3 each side).
5. Remove the side turn signal lamp assemblies.
6. Remove the 2 front bumper cover screws (1 each side).
- To install, tighten to 7 Nm (62 lb-in).

7. Remove the 2 front bumper cover-to-fender screws (1 each side).
- To install, tighten to 2 Nm (18 lb-in).

8. If equipped, disconnect the fog lamp electrical connectors and remove the front bumper cover.
9. To install, reverse the removal procedure.