Evaporator Core: Service and Repair

Evaporator Core

Removal and Installation

1. Remove the heater core and evaporator core housing. For additional information, refer to Heater Core And Evaporator Core Housing Service and Repair.

2. Remove the heater core and evaporator core housing dash panel seal.

3. Remove the 2 heater core and evaporator core tube bracket screws.

4. Remove the 3 air inlet duct screws and position the air inlet duct aside.

5. Remove the 2 RH temperature blend door actuator screws.

6. Disconnect the evaporator temperature sensor electrical connector and detach the connector from the evaporator core cover.

7. Remove the 5 evaporator core cover screws and position the evaporator core cover aside.

8. Remove the evaporator core.

9. Detach the evaporator temperature sensor from the evaporator core.

10. To install, reverse the removal procedure.