Connecting Rod, Engine
| Clearance to crankshaft-desired | 0.001-0.0027 inch | |
| Clearance to crankshaft-allowable | 0.001-0.0027 inch | |
| Connecting Rod, Piston and Rings | Connecting rod--piston pin bore diameter | 0.864-0.865 inch |
| Connecting rod-crankshaft bearing bore diameter | 2.234-2.24 inch | |
| Connecting rod-length (center-to-center) | 5.93 inch | |
| Alignment (bore-to-bore Max. Diff.) -Twist The pin bore and crank bearing bore must be parallel and in the same vertical plane within the specified total difference when measured at the ends of a 203 mm bar, 105.5 mm on each side of rod centerline. | 0.0015-0.984 inch | |
| Alignment (bore-to-bore Max. Diff.) bend | 0.0015-0.984 inch | |
| Side clearance (assembled to cranky-standard | 0 0.0006-0.0177 inch | |
| Side clearance (assembled to cranky-service limit | 0.02 inch | |
| Crankshaft main bearing journal taper | 0.0007 inch | |
| Crankshaft main bearing journal runout | 0.002 inch | |
| Crankshaft connecting rod journal taper | 0.0005 inch |