Steering Column Sensor Ring
Steering Column Sensor RingRemoval
CAUTION: The steering column must be in the locked position, or the lower end of the column wired in such a way that the steering column does not rotate, resulting in damage to the air bag sliding contact.
NOTE: Discard the upper intermediate shaft to steering column shaft bolt upon removal. Do not reuse; install a new bolt.
1. Remove the upper intermediate steering shaft to column shaft bolt.
1 Remove and discard the steering column shaft pinch bolt.
2 Slide the intermediate shaft yoke from the steering column.
2. Remove the steering wheel rotation sensor.
1 Disconnect the electrical connector.
2 Remove the screws.
3 Remove the steering wheel rotation sensor.
3. Remove the sensor ring.
1 Remove the steering column lower bearing spring.
2 Remove the sensor ring.
Installation
1. To install, reverse the removal procedure.
2. Install the steering wheel rotation sensor.
1 Position the steering wheel rotation sensor.
2 Install the screws.
3 Connect the electrical connector.
3. Use a new pinch bolt.