Camber and Caster Adjustment

1. Loosen the upper suspension arm nuts to a point where the joints are snug.




2. NOTE: A pry bar can be used between the front suspension upper arm and the frame pocket to aid in moving the arm.

To increase caster and camber, use the following steps.
1 To increase caster, move the front of the front suspension upper arm outboard and move the rear of the front suspension upper arm inboard.
2 To increase camber, move the front suspension upper arm outboard equally.





3. To decrease caster and camber, use the following steps.
1 To decrease caster, move the front of the front suspension upper arm inboard and move the rear of the front suspension upper arm outboard.
2 To decrease camber, move the front suspension on upper arm inboard equally.

4. NOTE: Each increment of the notches on the frame pocket represents 0.3 degree.

Set the caster and camber to specifications.
^ If a caster increase of 0.9 degree is required, move the front of the front suspension upper arm outboard by 3 notches and move the rear of the front suspension upper arm inboard by 3 notches.





5. Tighten the upper suspension arm nuts.