Camber and Caster Adjustment

1. Remove the alignment plate.
1 Remove the nuts.
2 Remove the alignment plate.





2. Install the washers and the nuts.





3. Note: A pry bar can be used between the upper control arm and the frame pocket to aid in moving the arm.

To increase the caster and camber, use the following steps.
1 To increase caster, move the front of the upper control arm outboard and move the rear of the upper control arm inboard.
2 To increase camber, move the upper control arm outboard equally.





4. To decrease caster and camber, use the following steps.
1 To decrease caster, move the front of the upper control arm inboard and move the rear of the upper control arm outboard.
2 To decrease camber, move the upper control arm inboard equally.

5. Note: Each increment of the notches on the frame pocket represents 0.4°.

Set the caster and camber to specifications.
^ If a caster increase of 1.2° is required, move the front of the upper control arm outboard by 3 notches and move the rear of the upper control arm inboard by 3 notches.





6. Tighten the nuts.