Rear Wiper Motor

REMOVAL

1. Disconnect battery ground cable, then remove wiper arm and blade assembly.
2. Remove liftgate inner trim panel, then the motor bracket attaching screw.
3. Pull motor assembly out of rubber grommet, disconnect motor electrical connector and disengage wiring locator pins, then remove motor assembly.

INSTALLATION

1. Position motor in liftgate rubber grommet and install attaching screws.
2. Connect motor electrical connector and install wiring locator pins.
3. Install wiper arm and blade assembly, then connect battery ground cable, and check for proper operation of wiper.
4. Install liftgate inner trim panel.