Block Heater - Replacement When Removing Motor Mounts

Article No.
97-9-19

04/28/97

BLOCK HEATER - REMOVAL OF BLOCK HEATER WHEN REPLACING MOTOR MOUNTS

LIGHT TRUCK:
1991-94 EXPLORER

ISSUE:
When installing a Vibration/Shake Kit per TSB 96-4-15, 96-4-16, or 96-4-17, the original block heater (if equipped) must be removed to allow installation of the revised engine mounts. The block heater cannot be reinstalled.

ACTION:
When performing any of the TSBs listed above, remove the previous block heater (if equipped) and install a revised design block heater into a new location on the block. Refer to Instruction Sheet 7222, included in the Block Heater Kit, for details.

Install the Block Heater Kit only if the vehicle was originally equipped with a block heater.

The Block Heater Kit (F67Z-6D008-EA) consists of the following:

^ One (1) Heater Element

^ One (1) Wiring Assembly

^ One (1) Instruction Sheet (1.5 7222)

PART NUMBER PART NAME

F67Z-6D008-EA Block Heater Kit

OTHER APPLICABLE ARTICLES: 96-4-15, 96-4-16, 96-4-17

WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage

OPERATION DESCRIPTION TIME

970919A Install Block Heater Kit 0.4 Hr.
(this operation to be used
when performing other
listed TSBs at the same
time)

970919B Install Block Heater Kit 0.8 Hr.
(this operation to be used
only if previous listed TSBs
were performed during
previous repair visit)

DEALER CODING
CONDITION
BASIC PART NO. CODE
6K007 33

OASIS CODES: 205000, 499000, 703000, 703200, 703300, 703400