Removal and Installation

1. Remove caliper, leaving brake hose connected.
2. Secure caliper with wire so that caliper is not hanging with weight on brake hose.
3. Compress anti-rattle clip, then remove inner pad from caliper.
4. Press each ear of outer pad away from caliper, slide torque buttons out of retention notches and slide pad off caliper.
5. Reverse procedure to install, noting the following:
a. Use an eight inch C-clamp and a worn inner pad or block of wood to bottom out caliper piston in bore.
b. Install new anti-rattle clip on lower end of inner pad.
c. Refill brake fluid reservoir.